Deluxe Commercial Wet Belt Sander

ALL PRICES IN US $

25" x 13" x 17"

Shipping weight 65 lbs.

Shipped with motor attached ready to plug in and operate.

Also includes 4" Back Plate at no additional cost.

Same as #760 except this unit comes with 1/2 HP motor and 13" hight back plate that makes it possible to we sand flat surfaces vertically.

WATER FEED

A wet belt sander requires some kind of water supply to keep the belt wet.   Some alternatives, in order of efficiency: 

1. Plumb direct to a household or shop water line with a hose feeding water to the water nozzle.
2. A submersible pump in a tank or bucket of water pumping water to the water nozzle.
3. A pressure tank.   Manually pump to build pressure to pump water to the water nozzle.
4. A wet sponge wedged behind the belt. 

DRAIN 

You can let the catch basin fill up and remove the drain plug to drain out any water contained or you can install a hose to provide continuous drain.    WARNING….. drain into a bucket or catchment basin.  Do NOT drain into your household or shop drains.   The glass dust and particles of silicon carbide that come of the sanding belt can build up inside a drain and set up solid like concrete.   Cleaning out a plugged drain can cost more than you paid for the belt sander.

BELT WEAR

Silicon carbide doesn’t wear down but instead breaks down.  As you use the belt, bits of silicon carbide will either break off completely or chip into smaller bits.    Some users think they can use worn coarser grit belts as finer grit.   WRONG!   Belts do not wear down uniformly.   As it wears, a 100 grit belt will start to produce a finish like a 200 grit belt but if you use it for a 200 grit finish, you will get a 200 grit surface but one with a good number of 100 grit scratches.

 FOB Redlands, CA

Contact us for a freight quote.

Victorian Art glass is a distributor for Covington Engineering and will be pleased to provide a quote on any of their fine products.